Boat is located in Rockport,TX...
- Phone number removed -
- Email address removed -
Located in Rockport, TX
37ft. JUNA steel hull cutter rigged. George Buehler design Juna Junosdautter. Simple and rugged. Launched in 2014.
LOD: 37’ 11”
LWL 31’ 1”
Beam 10’ 4”
Draft 5’ 7”
Traditionally rigged with hand spliced galvanized wire that is parceled and served. The main has three reef points. A club footed staystail with two reef points. The jib can be handled on deck rather than out on the bow sprit.
Sail Area: 710 sq. ft.
Yanmar 22hp with a 3.1:1 gearbox with a 18” x 13” bronze three-bladed propeller.
Water: 63 US gals.
Fuel: 36 US gals
Two size 31 12-volt batteries. 40 Watt solar panel
Monitor wind vane
ICOM 710 SSB
Diesel fuel for the engine and the two burner stove and oven. All berths have 6’ 6” headroom. The saloon has 6’6” head room.
75 lb. Luke anchor
35 lb. CQR anchor
Fortress FX-23 anchor
Simpson Lawrence Hy-speed 510 manual windlass
Currently a porti-potty is installed but I have a marine head ready to install.
9½’ Nutshell Pram designed by Joel White. It has Sitka spruce mast, boom and yard. Dacron sail with single set of reef points. A pair of ash oars, bronze oar locks. The interior and exterior was painted with CEP epoxy then top coated....Read full description