Power BoatsWashingtonSchooner Creek Boat WorksRobert Perry 28' Classic Launch With Trailer
This launch is powered by a single 425 horsepower freshwater cooled Marine Power 502 fuel injected gasoline engine coupled to a Borg Warner Velvet Drive Model 20-02-003 v-drive marine transmission. She runs a 1&1/2" diameter Aquamet 22 shaft with Michigan DynaJet 16"X18" nibral prop. All running gear is in "as new" condition with fewer than 30 total engine time. Recently serviced this August. 12 volt, 2 batteries charged by: engine, shore power The hull and deck were produced using a composite sandwich that captures 3/16" Honduran mahogany between layers of epoxy saturated 6 oz e-glass on the outside and 1/2" H80 high density foam coring backed by 1/4" okoume planking and carbon fiber on the inside to make an incredibly strong yet lightweight yacht. Her exterior is finished with six coats of Awlbright high gloss clear polyurethane for beauty and ease of maintenance.
Okoume is a type of Mahogany known for its high strength to weight ratio.
Schooner Creek Boat Works has been a leading builder of custom boats using modern light weight composite systems. They have been in business in Portland, Oregon since the mid 1970's and have a reputation for high quality work. Following the traditional launch design this boat has luxurious forward and aft seating areas separated by an integral bulkhead. The upholstery is Ultraleather and her soles are solid teak strips. The helm is located forward to starboard and includes comprehensive instrumentation, throttle and shift controls, auxiliary switches and an entertainment system with independently-adjusted speakers in the seating areas. Both seating areas have Heater Craft marine heaters to keep cruisers comfortable in chilly weather. Aft of the second row of seating is the engine hatch and it it followed by a lazarette hatch which gives access to the mufflers, steering quadrant and bilge pump. On the stern is a beautiful teak swim step which is built as an integral part of the hull. 1 anchors
(13 lb galvanized Danforth)
25'0" of chain
200'0" of warp
Steering is hydraulic Vetus
Morse single lever engine controls
Two automatic electric bilge pumps
Dual Kahlenberg air horns with dedicated compressor
Guest spotlight with helm remote control
Battery charger with shore power connection and 30 amp shorepower cord
Dual group 27 batteries with parallel 2 bilge pumps (0 manual / 2 Electric)...Read full description